This report offers highway engineers guidance in designing interchanges so as to reduce the likelihood of truck accidents on highway interchanges. This report summarizes research showing that the interaction between truck dynamics and interchange geometry can contribute to rollovers, jackknifes, and other loss-of-control accidents. Engineers can apply corrective actions to six specific ramp design features that were found to contribute to truck accidents: poor transitions to superelevation, abrupt changes in compound curves, short deceleration lanes preceding tight-radius exits, curbs placed on the outside of ramp curves, lowered friction levels on high speed ramps, and substantial downgrades leading to tight ramp curves. Countermeasures for these design problems include incorporating a greater safety margin into formulations for side friction factors, reviewing and modifying posted speed limits, improving curve condition and downgrade signs at interchanges, increasing deceleration lane length, overlaying curbs with wedges of pavement or eliminating curbs altogether, resurfacing ramps with high-friction overlays, and redesigning sites where accidents are common.
This report describes a study of ramp signing for trucks. The research addressed methods for treating interchange ramps that are prone to cause high c...
Texas Southern University. Center for Transportation Training and Research
2001-01-01
Abstract:
This manual is designed to assist TxDOT planners and engineers in making ramp location and design decisions that consider traffic resulting from adjac...
Links with this icon indicate that you are leaving a Bureau of Transportation
Statistics (BTS)/National Transportation Library (NTL)
Web-based service.
Thank you for visiting.
You are about to access a non-government link outside of
the U.S. Department of Transportation's National
Transportation Library.
Please note: While links to Web sites outside of DOT are
offered for your convenience, when you exit DOT Web sites,
Federal privacy policy and Section 508 of the Rehabilitation
Act (accessibility requirements) no longer apply. In
addition, DOT does not attest to the accuracy, relevance,
timeliness or completeness of information provided by linked
sites. Linking to a Web site does not constitute an
endorsement by DOT of the sponsors of the site or the
products presented on the site. For more information, please
view DOT's Web site linking policy.
To get back to the page you were previously viewing, click
your Cancel button.
United States Department of Transportation
[PDF-474.79 KB]
