During the investigation of aviation accidents, postmortem specimens from accident victims are submitted to the Federal Aviation Administration’s Civil Aerospace Medical Institute (CAMI) for toxicological analysis. The first, and perhaps most important, step in the analysis process is the initial screening of biological specimens for illicit, medically prescribed, and over-the-counter compounds that may be present and could have been the cause of the accident. Currently, our General Unknown Screening (GUS) procedure involves both gas chromatography/mass spectrometry (GC/MS), liquid chromatography/diode array detection (LC/DAD) and fluorescence detection techniques. Both techniques have inherent limitations that prevent the detection of certain types of compounds. LC/DAD, however, is more limited due to poor sensitivity and specificity. Therefore, our laboratory developed and validated an LC/MS/MS procedure that provides far superior sensitivity and specificity to that of LC/DAD. The combination of GC/MS with LC/MS/MS will allow for the detection of more compounds at lower concentrations than our current techniques.
Content Notes:
Work was accomplished under approved task AM- AM-B-05-TOX-204
Benzodiazepines, a class of drugs known to cause central nervous system depression, are widely prescribed for a variety of different medical condition...
During the investigation of aviation accidents, postmortem specimens from accident victims are submitted to the Federal Aviation Administration’s Ci...
Links with this icon indicate that you are leaving a Bureau of Transportation
Statistics (BTS)/National Transportation Library (NTL)
Web-based service.
Thank you for visiting.
You are about to access a non-government link outside of
the U.S. Department of Transportation's National
Transportation Library.
Please note: While links to Web sites outside of DOT are
offered for your convenience, when you exit DOT Web sites,
Federal privacy policy and Section 508 of the Rehabilitation
Act (accessibility requirements) no longer apply. In
addition, DOT does not attest to the accuracy, relevance,
timeliness or completeness of information provided by linked
sites. Linking to a Web site does not constitute an
endorsement by DOT of the sponsors of the site or the
products presented on the site. For more information, please
view DOT's Web site linking policy.
To get back to the page you were previously viewing, click
your Cancel button.