Kandhal, P. S., & Mallick, R. B. (1997). Longitudinal Joint Construction Techniques for Asphalt Pavements (Report No. Report No: NCAT Report No. 97-4). National Center for Asphalt Technology (U.S.). https://rosap.ntl.bts.gov/view/dot/13984
Kandhal, Prithvi S. and Rajib B. Mallick. Longitudinal Joint Construction Techniques for Asphalt Pavements. Report no. Report No: NCAT Report No. 97-4. National Center for Asphalt Technology (U.S.), 1997. https://rosap.ntl.bts.gov/view/dot/13984.
Kandhal, Prithvi S., and Rajib B. Mallick Longitudinal Joint Construction Techniques for Asphalt Pavements. National Center for Asphalt Technology (U.S.), 1997, Report no. Report No: NCAT Report No. 97-4, ROSA P. https://rosap.ntl.bts.gov/view/dot/13984.
Thirty hot mix asphalt (HMA) test sections were constructed in Michigan (1992), Wisconsin (1992), Colorado (1994), and Pennsylvania (1995) to evaluate the effectiveness of twelve different longitudinal joint construction techniques. The performance of these test sections was evaluated in 1996 after one to four years in service. The joints with high densities generally show better performance than those with relatively low densities. The Michigan joint technique (12.5 mm vertical offset and 12:1 taper) appears to have the best potential of obtaining a satisfactory longitudinal joint. The cutting wheel and the edge restraining device techniques have good potential but are too much operator dependent to obtain consistent results. Among the three different joint rolling techniques used in all four projects, rolling the joint from hot side generally gave the best performance followed by rolling from hot side 152 mm away from the joint. Paver manufacturers should consider modifying the paver design to obtain a Michigan type, high density unconfined wedge in the lane paved first. Highway agencies should specify minimum compaction levels to be achieved at the longitudinal joint. Tables, figures, references. 26p.
Kandhal, P. S., & Mallick, R. B. (1997). Longitudinal Joint Construction Techniques for Asphalt Pavements (Report No. Report No: NCAT Report No. 97-4). National Center for Asphalt Technology (U.S.). https://rosap.ntl.bts.gov/view/dot/13984
Kandhal, Prithvi S. and Rajib B. Mallick. Longitudinal Joint Construction Techniques for Asphalt Pavements. Report no. Report No: NCAT Report No. 97-4. National Center for Asphalt Technology (U.S.), 1997. https://rosap.ntl.bts.gov/view/dot/13984.
Kandhal, Prithvi S., and Rajib B. Mallick Longitudinal Joint Construction Techniques for Asphalt Pavements. National Center for Asphalt Technology (U.S.), 1997, Report no. Report No: NCAT Report No. 97-4, ROSA P. https://rosap.ntl.bts.gov/view/dot/13984.
ROSA P serves as an archival repository of USDOT-published products including scientific
findings, journal articles, guidelines, recommendations, or other information authored or co-authored by
USDOT or funded partners. As a repository, ROSA P retains documents in their original published format to
ensure public access to scientific information.
Links with this icon indicate that you are leaving a Bureau of Transportation
Statistics (BTS)/National Transportation Library (NTL)
Web-based service.
Thank you for visiting.
You are about to access a non-government link outside of
the U.S. Department of Transportation's National
Transportation Library.
Please note: While links to Web sites outside of DOT are
offered for your convenience, when you exit DOT Web sites,
Federal privacy policy and Section 508 of the Rehabilitation
Act (accessibility requirements) no longer apply. In
addition, DOT does not attest to the accuracy, relevance,
timeliness or completeness of information provided by linked
sites. Linking to a Web site does not constitute an
endorsement by DOT of the sponsors of the site or the
products presented on the site. For more information, please
view DOT's Web site linking policy.
To get back to the page you were previously viewing, click
your Cancel button.