- Admixtures 1
- Aggregate gradation 1
- Aggregates 1
- Alkali cement 1
- Asphalt cement 1
- Asphalt concrete 2
- Asphalt content 1
- Compressive strength 1
- Evaluation 2
- Fly ash 1
- Microwave devices 1
- Mix design 3
- Moisture content 2
- Moisture correction 1
- Portland cement concrete 1
- retention factor 1
- Samples 1
- Testing 2
(Max 200)
- Admixtures (1)
- Aggregate gradation (1)
- Aggregates (1)
- Alkali cement (1)
- Asphalt cement (1)
- Asphalt concrete (2)
- Asphalt content (1)
- Compressive strength (1)
- Evaluation (2)
- Fly ash (1)
- Microwave devices (1)
- Mix design (3)
- Moisture content (2)
- Moisture correction (1)
- Portland cement concrete (1)
- retention factor (1)
- Samples (1)
- Testing (2)
- :Maloney, Michael J. ;Sullivan, Jack1984-07-01:The investigation of fly ash as an admixture in Portland cement concrete (PCC) was divided into two phases. Phase I consisted of an experimental progr...
- :Silbernagel, Ivan P. ;Sullivan, Jack1985-05-01:The purpose of this report is to compare the differences in asphalt contents determined after correction of mix and extracted aggregate weights for mo...
- :Silbernagel, Ivan P. ;Sullivan, Jack1985-03-01:The purpose of this report is to identify the difference, if any, in AASHTO and OSHD test procedures and results. This report addresses the effect of ...
Exit Notification/Disclaimer Policy
Thank you for visiting.
You are about to access a non-government link outside of the U.S. Department of Transportation's National Transportation Library.
Please note: While links to Web sites outside of DOT are offered for your convenience, when you exit DOT Web sites, Federal privacy policy and Section 508 of the Rehabilitation Act (accessibility requirements) no longer apply. In addition, DOT does not attest to the accuracy, relevance, timeliness or completeness of information provided by linked sites. Linking to a Web site does not constitute an endorsement by DOT of the sponsors of the site or the products presented on the site. For more information, please view DOT's Web site linking policy.
To get back to the page you were previously viewing, click your Cancel button.